Redline Communications RDL-2000 Manuel de service télécharger pdf (Page 51)

RDL-2000 Installation Guidelines

5.2.4 Throughput Test

1. On PC #1, go to the Throughput Test screen. Set the address to

192.168.25.20 (PC #2), set the data rate to 10 Mbps, and click the Start

button to begin transmitting data.

2. On PC #2, go to the Throughput Test screen and click the Rx button to start

listening for data. Observe that the Rx counter adjacent to the Rx button

indicates that data is being received and the rate is approximately 10 Mbps.

3. On PC #1, adjust the slider to increase the data rate and observe that PC #2

is correctly receiving at the same rate.

4. Click the End button on both PCs to stop the throughput test.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 46 47 48 49 50 51 52

Pas de commentaire

Redline Communications RDL-2000 Manuel de service Page 51