Redline Communications RDL-2000 Manuel de service télécharger pdf (Page 28)

RDL-2000 Installation Guidelines

The Ethernet cable must be inserted through the mounting plate and grommet

before the RJ-45 connector is installed on outdoor Ethernet cable.

When assembled correctly, the Ethernet port seal will be weather-resistant.

Use the following steps to:

1. Install the Ethernet port weatherproof grommet and clamp onto the cable.

a. Insert the grommet into the grommet clamping plate. The grommet must be

threaded through the metal clamping plate first

. This operation will not be

possible after the Ethernet cable has been inserted through the grommet.

b. Thread the Ethernet cable through the rubber grommet/metal clamping plate

combination (see Figure 17). The large end of the grommet should be

oriented towards the unterminated end of the cable.

Figure 17: Installation - Ethernet Port Cover Plate & Grommet

2. Terminate the cable using the supplied RJ-45 connector. The RDL-2000 Ethernet

port uses a custom pinout for the PoE signals. All Ethernet cables from the

indoor PoE to the outdoor RDL-2000 must

be terminated to match the

specifications in Table 9.

Table 9: Installation - Outdoor Ethernet Cable Termination

RJ-45 Conn. Signal Color Code Identification

RX +

White / Orange

Rx -

Orange

Tx +

White / Green

4 No Connection

5 No Connection

6 Tx - Green

7 +Ve Blue

-Ve

Brown

Note: Color codes are provided for convenience only. All signals must match the

connector assignments. Do not

terminate wires to pins 4 an d 5 on the RJ-45

connector.

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Pas de commentaire

Redline Communications RDL-2000 Manuel de service Page 28