Redline Communications RDL-2000 Manuel de service télécharger pdf (Page 41)

RDL-2000 Installation Guidelines

4.5.9 Configure PTP Slave

The following instructions must be performed in the order listed. The configuration listed

here is to facilitate installation only. Refer to your detailed RF plan for any other required

parameter settings.

1. Start the Link Manager (Start-> Link_Manager-> Link_Manager), click 'S' on

the toolbar to start a session, and login as Admin.

2. Display the License screen and Drag & Drop the licence file for this MAC

address onto the license screen. Click Submit to activate the license. The

RDL-2000 will automatically reboot.

Important: Exit from the Link Manager after changing the license file, and

then re-start the Link manager application to load the new RDL-2000 settings.

3. PTP Slave Link Configuration Screen

a. Channel BW (see RF plan).

b. Enable MIMO = (Enabled)

c. Unit Type = PTP Slave

d. Click Submit Parameters (RDL-2000 may automatically reboot).

Figure 29: Link Manager - Slave - Link Configuration Screen

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Pas de commentaire

Redline Communications RDL-2000 Manuel de service Page 41