Redline Communications AN-50e Spécifications télécharger pdf (Page 18)

sweep, the higher the received power level is. It was observed that small aiming differences did

not result in a significant change in signal quality since the beam pattern of the antennas is

reasonable flat near zero degrees.

Fig. 3.7 System Status Page. The system status page of the Redline web interface displays information such as

Received Signal Strength (RSSI), Signal to Noise and Distortion Ratio (SINADR), and packet retransmission data.

Fig. 3.8 A typical output graph from RF Monitor. This data, along with the measured throughput can be used to

plot throughput vs. SINADR. The lighter line on the SINADR plot is the transmit power.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

Pas de commentaire

Redline Communications AN-50e Spécifications Page 18